Hyundai Elantra: Interior Trim / Center Pillar Trim Repair procedures

Replacement
[Center pillar lower trim]
   
•
Put on gloves to prevent hand injuries.
   
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Carefully remove the front door body side weatherstrip.
2.
Carefully remove the rear door body side weatherstrip.
3.
Remove the front door scuff trim.
(Refer to Interior Trim - "Door Scuff Trim")
4.
Remove the rear door scuff trim.
(Refer to Interior Trim - "Door Scuff Trim")
5.
Using a screwdriver or remover, remove the center pillar lower trim (A).

6.
To intall, reverse the removal procedure.
   
•
Replace any damaged clips (or pin-type retainers).
[Center pillar upper trim]
   
•
Put on gloves to prevent hand injuries.
   
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the center pillar lower trim.
(Refer to Interior Trim - "Center Pillar Trim")
2.
Remove the anchor seat belt connector.
(Refer to Restraint - "Emergency Fastening Device (EFD)")
3.
Using a screwdriver or remover, remove the center pillar upper trim (A).

4.
To intall, reverse the removal procedure.
   
•
Replace any damaged clips (or pin-type retainers).
Center Pillar Trim Components and Components Location
Component Location 1. Center pillar lower trim2. Center pillar upper trim ...

Rear Transverse Trim Components and Components Location
Component Location 1. Rear transverse trim ...

Other information:

Hyundai Elantra AD (2016-2020) Owners Manual: High beam operation
To turn on the high beam headlamp, push the lever away from you. The lever will return to its original position. The high beam indicator will light when the headlamp high beams are switched on. To turn off the high beam headlamp, pull the lever towards you. The low beams will turn on. WAR ...

Hyundai Elantra AD (2016-2020) Service Manual: Start/Stop Button Repair procedures
Removal 1. Disconnect the negative(-) battery terminal. 2. Remove the crash ped lower panel. (Refer to Body - "Crash Ped Lower Panel") 3. Remove the start/stop button (B) after disconnect the connector (A). Installation 1. Install the start/stop button. 2. Install the crash pa ...

© 2018-2026 www.helantraad.com