Hyundai Elantra: Body Dimensions / Body Panel Gaps Body Repair

Under Body Body Repair
Projected Dimensions * These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Actual Measurement Dimensions * These dimensions indicated in this f ...

Cross Member Body Repair
Front Cross Member * These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Rear Cross Member * These dimensions indicated in this figure are actu ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Engine Control Module (ECM) Repair procedures
Removal     • When replacing the ECM, the vehicle equipped withthe immobilizer must be performed procedure asbelow. [In the case of installing used ECM] 1) Perform "ECM Neutral mode" procedure with GDS. (Refer to Body Electrical System - "Immobilizer System") 2) After ...

Hyundai Elantra AD (2016-2020) Service Manual: Blower Resistor (Manual) Repair procedures
Inspection 1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad center panel. ...

© 2018-2026 www.helantraad.com