Hyundai Elantra: Front Door / Front Door Trim Repair procedures

Hyundai Elantra AD (2016-2020) Service Manual / Body (Interior and Exterior) / Front Door / Front Door Trim Repair procedures

Replacement

•	Put on gloves to prevent hand injuries.

•	When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

•	Be careful not to scratch the door trim and other parts.

1.	Using a screwdriver or remover, remove the front door quadrant inner cover (A).

2.	After loosening the mounting screws, remove the lower part of the front door trim (A) using a flat-tip screwdriver.

3.	Remove the front door inside handle cage (A).

4.	Disconnect the front door lamp connector (A) and power window switch connector (B).

To intall, reverse the removal procedure.

•	Make sure the connector is connected properly.

•	Make sure the door locks / unlocks and opens / closes properly.

•	Replace any damaged clips (or pin-type retainers).

•	Make sure the glass is operated properly.

Front Door Trim Components and Components Location

Component Location 1. Front door trim ...

Front Door Inside Handle Repair procedures

Replacement 1. Remove the front door trim. (Refer to Front Door - "Front Door Trim") 2. After loosening the mounting screws, remove the front door inside handle (A). 3. To intall, reverse ...

Other information:

Hyundai Elantra AD (2016-2020) Owners Manual: Special Driving Conditions
Hazardous Driving Conditions When hazardous driving elements are encountered such as water, snow, ice, mud and sand, take the below suggestions: Drive cautiously and keep a longer braking distance. Avoid abrupt braking or steering. When your vehicle is stuck in snow, mud, or sand, use sec ...

Hyundai Elantra AD (2016-2020) Service Manual: Starter Repair procedures
Removal 1. Disconnect the battery negative terminal. 2. Remove the battery tray. (Refer to Engine Electrical System - "Battery") 3. Remove the air duct and air cleaner assembly. (Refer to Engine Mechanical System - "Air Cleaner") 4. Disconnect the starter cable (A) from the B te ...