Hyundai Elantra: Body (Interior and Exterior) / Trunk Trim. Repair procedures

Hyundai Elantra AD (2016-2020) Service Manual / Body (Interior and Exterior) / Trunk Trim. Repair procedures

Repair procedures

Replacement

•	Put on gloves to prevent hand injuries.

•	When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

•	When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Remove the rear seat cushion assembly. (Refer to Rear Seat - "Rear Seat Assembly")

2.	Remove the rear seat back assembly. (Refer to Rear Seat - "Rear Seat Assembly")

3.	Remove the rear door scuff trim. (Refer to Interior Trim - "Door Scuff Trim")

4.	After loosening the mounting screws, then remove the partition center trim (A).

5.	Remove the luggage covering mat (B).

6.	Remove the rear transverse trim (C).

7.	Remove the rear wheel house trim (D).

8.	After loosening the mounting screws, remove the luggage side trim (E).

To intall, reverse the removal procedure.

•	Replace any damaged clips.

[Folding type]

1. Rear transverse trim
2. Luggage covering mat
3. Fire extinguisher
4. Luggage net
5. Luggage side trim [LH]

6. Luggage side trim [RH]
7. Rear package tray trim
8. Rear wheel house trim [LH]
9. Rear wheel house trim [RH]
10. Partition center trim

[Bench type]

1. Rear transverse trim
2. Luggage covering mat
3. Fire extinguisher
4. Luggage net
5. Luggage side trim [LH]

6. Luggage side trim [RH]
7. Rear package tray trim
8. Rear wheel house trim [LH]
9. Rear wheel house trim [RH]
10. Partition center trim

Rear Package Tray Trim Repair procedures

Replacement • Put on gloves to prevent hand injuries. • When removing with a flat-tip screwdriver or remover, wrap protective tape around ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Cylinder Head Components and Components Location
Components 1. Camshaft bearing cap2. Camshaft front bearing cap3. Exhaust camshaft4. Intake camshaft5. Exhaust CVVT assembly6. Intake CVVT assembly7. Cam carrier8. Cylinder head9. Cylinder head gasket10. Retainer lock11. Retainer 12. Valve spring13. Valve stem seal14. Valve 15. Swing arm16. Hyd ...

Hyundai Elantra AD (2016-2020) Service Manual: Camshaft Position Sensor (CMPS) Repair procedures
Inspection 1. Check the signal waveform of the CMPS and CKPS using the GDS. Specification : Refer to "Wave Form" Removal • DON’T remove the camshaft position sensor during engine running or right after engine stops, or a scald by the flowed out engine ...