Hyundai Elantra: Interior Trim / Rear Package Tray Trim Repair procedures

Replacement
   
•
Put on gloves to prevent hand injuries.
   
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the rear seat cushion assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
2.
Remove the rear seat back assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
3.
Slighty remove the rear door weatherstrip.
4.
Remove the rear door scuff trim.
(Refer to Interior Trim - "Door Scuff Trim")
5.
Remove the rear pillar trim.
(Refer to Interior Trim - "Rear Wheel House Trim")
6.
Loosen the clips and screws, remove the luggage partition side trim (A).

7.
Using a screwdriver or remover, remove the rear wheel house trim (A).

8.
After loosening the mounting bolt, remove the rear seat belt lower anchor (A).

Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

[Side]

[Center]

9.
Using a screwdriver or remover, remove the package tray trim (A).

10.
To intall, reverse the removal procedure.
   
•
Replace any damaged clips (or pin-type retainers).
Rear Package Tray Trim Components and Components Location
Component Location 1. Package tray trim ...

Trunk Trim. Repair procedures
Repair procedures Replacement     • Put on gloves to prevent hand injuries.     • When removing with a flat-tip screwdriver or remover, wrap prot ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Power Window Switch Repair procedures
Inspection [Driver Power Window Switch] 1. Disconnect the negative (-) battery terminal. 2. Remove the driver door trim. (Refer to Body - "Front Door Trim") 3. Disconnect the power mirror switch connector from the door trim. 4. Check for continuity between the terminals in each swi ...

Hyundai Elantra AD (2016-2020) Owners Manual: Selecting a Child Restraint System (CRS)
When selecting a CRS for your child, always: Make sure the CRS has a label certifying that it meets applicable Federal Motor Vehicle Safety Standards (FMVSS 213). Select a child restraint based on your child’s height and weight. The required label or the instructions for use typically ...

© 2018-2026 www.helantraad.com