Hyundai Elantra: General Information / Troubleshooting
| Troubleshooting |
| Trouble Symptom | Cause of the symptom | Remedy |
| Excessive play in steering | Loose U-joint bolt | Retighten or replace as necessary |
| Loose yoke plug | Retighten | |
| Loose steering gear mounting bolts | Retighten | |
| Loose or worn tie rod end | Retighten or replace as necessary | |
| Steering wheel does not return to its original position | Excessive turning resistance of tie rod end | Replace |
| Yoke plug excessively tight | Adjust | |
| Tie rod and/or ball joint cannot turn smoothly | Replace | |
| Loose mounting of gear box at the subframe | Retighten | |
| Worn steering shaft joint and/or body grommet | Correct or replace | |
| Distorted rack | Replace | |
| Rattling or chucking noise in the rack and pinion | Loose steering gear box mounting | Reposition |
| Loose tie rod end and/or ball joint | Repace | |
| Worn tie rod and/or ball joint | Repace | |
| Loose yoke plug | Replace | |
Specifications
Specifications
ItemSpecificationTypeElectric Power Steering SystemSteering gearTypeRack & PinionRack stroke154±1 mm (6.07±0.04 in)Steering angle (Max.)Inner39.4°+0.5° / -1.5°Outer32.6°
...
Repair procedures
Inspection
Steering Wheel Play Inspection
1.
Turn the steering wheel so that the front wheels can face straight ahead.
2.
Measure the distance the steering wheel can be turned without moving ...
Other information:
Hyundai Elantra AD (2016-2020) Service Manual: Auto Light Sensor Repair procedures
Inspection
Check if the auto light control operates like a timing chart
shown below. Tail lamp output and head lamp (Low) output is controlled
based on the auto light sensor's input (illumination intensity) when the
Auto Light Switch in Multi-Function Switch is turned ON, and the
vehicle ...
Hyundai Elantra AD (2016-2020) Service Manual: Rear Glass Defogger Printed Heater Repair procedures
Inspection
•
Wrap tin foil around the end of the voltmeter test lead to
prevent damaging the heater line. Apply finger pressure on the tin foil,
moving the tin foil along the grid line to check for open circuits.
1.
Turn on the defogger switch and use a voltme ...
