Hyundai Elantra: What To Do in an Emergency / Tire Pressure Monitoring System (TPMS)
■ Supervision cluster
(1) Low Tire Pressure / TPMS Malfunction Indicator Lamp
(2) Low Tire Pressure / Tire Pressure Monitor / TPMS Malfunction Display (shown on the cluster LCD display)
- Check Tire Pressure
- Tire Pressure Monitoring System
- Low Tire Pressure LCD Display with Position Indicator
- TPMS Malfunction Indicator
- Changing a Tire with TPMS
If the Engine Overheats
If your temperature gauge indicates overheating, you experience a loss of power,
or hear loud pinging or knocking, the engine may be overheating. If this happens,
you should:
1. Pull off the road ...
Check Tire Pressure
■ Supervision cluster
You can check the tire pressure in the Assist Mode on the cluster. Refer
to the "LCD Display Mode" section in chapter 3.
A "Drive to display" mes ...
Other information:
Hyundai Elantra AD (2016-2020) Service Manual: Purge Control Solenoid Valve (PCSV) Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the PCSV connector.
3.
Measure resistance between the PCSV terminals 1 and 2.
4.
Check that the resistance is within the specification.
Specification : Refer to "Specification"
Removal
1.
Turn the ignition switch O ...
Hyundai Elantra AD (2016-2020) Service Manual: Temperature Control Actuator Description and Operation
Description
The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows.
The signal from the control unit adjusts the position of the
temperature door by operating the temperature switch. Then the
temperature will be regulated by ...
