Hyundai Elantra: Tire Pressure Monitoring System (TPMS) / TPMS Malfunction Indicator
The TPMS Malfunction Indicator will illuminate after it blinks for approximately one minute when there is a problem with the Tire Pressure Monitoring System.
Have the system checked by an authorized HYUNDAI dealer as soon as possible.
NOTICE
If there is a malfunction with the TPMS, the individual tire pressures in the cluster LCD display will not be available. Have the system checked by an authorized HYUNDAI dealer as soon as possible.
NOTICE
The TPMS Malfunction Indicator may illuminate after blinking for one minute if the vehicle is near electric power supply cables or radio transmitters such as police stations, government and public offices, broadcasting stations, military installations, airports, transmitting towers, etc.
Additionally, the TPMS Malfunction Indicator may illuminate if snow chains are used or electronic devices such as computers, chargers, remote starters, navigation, etc. This may interfere with normal operation of the TPMS.
Low Tire Pressure LCD Display with Position Indicator
â– Supervision cluster
When the tire pressure monitoring system warning indicators are illuminated and
the warning message is displayed on the cluster LCD display, one or more of your
tires is ...
Changing a Tire with TPMS
If you have a flat tire, the Low Tire Pressure and LCD position indicator will
come on. Have the flat tire repaired by an authorized HYUNDAI dealer as soon as
possible or replace the flat tire wit ...
Other information:
Hyundai Elantra AD (2016-2020) Owners Manual: Limitations of the System
The Forward Collision Avoidance Assist (FCA) system is designed to monitor the
vehicle ahead on the roadway through camera recognition to warn the driver that
a collision is imminent, and if necessary, apply emergency braking.
In certain situations, the camera may not be able to detect the vehi ...
Hyundai Elantra AD (2016-2020) Service Manual: Accelerator Position Sensor (APS) Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Turn the ignition switch ON.
3.
Measure the output voltage of the APS 1 and 2 at C.T and W.O.T.
Specification : Refer to "Specification"
...
