Ventilation
1. Select the Face Level mode.
2. Set the air intake control to the outside (fresh) air position.
3. Set the temperature control to the desired position.
4. Set the fan speed control to the desired speed.
Heating
1. Select the Floor Level mode.
2. Set the air intake control to the outside (fresh) air position.
3. Set the temperature control to the desired position.
4. Set the fan speed control to the desired speed.
5. If dehumidified heating is desired, turn the air conditioning system on. If
the windshield fogs up, select the Floor & Defrost
mode or press the Front Defrost
mode.
Operation Tips
Air conditioning
All HYUNDAI Air Conditioning Systems are filled with environmentally friendly R-134a refrigerant.
1. Start the engine.
2. Push the air conditioning button.
3. Set the mode to the Face Level
mode.
4. Set the air intake control to the recirculated air position. However, prolonged operation of the recirculated air position will excessively dry the air. In this case, change the air position.
5. Adjust the fan speed control and temperature control to maintain maximum comfort.
When maximum cooling is desired, set the temperature control to the extreme left position then set the fan speed control to the highest speed.
NOTICE
When using the air conditioning system, monitor the engine temperature gauge closely while driving up hills or in heavy traffic when outside temperatures are high. Air conditioning system operation can cause engine overheating. Continue to use the blower fan, but turn the air conditioning system off if the engine temperature gauge indicates engine overheating.
Air conditioning system operation tips
Hyundai Elantra AD (2016-2020) Owners Manual: Changing tires
WARNING
A vehicle can slip or roll off of a jack causing serious injury or death to
you or those nearby. Take the following safety precautions:
Never place any portion of your body under a vehicle that is supported
by a jack.
NEVER attempt to change a tire in the lane of traffic. ALWAYS ...
Hyundai Elantra AD (2016-2020) Service Manual: Rear Torsion Beam Axle Repair procedures
Removal
[Disc type]
1.
Loosen the wheel nuts slightly.
2.
Raise the vehicle, and make sure it is securely supported.
3.
Remove the rear wheel and tire (A) from front hub.
Tightening torque :
107.9 ~ 127.5 N.m (11.0 ~ 13.0 kgf.m, 79.6 ~ 94.0 lb-ft)
•
B ...