Hyundai Elantra: Roof Trim / Sunvisor Repair procedures

Replacement
   
Put on gloves to prevent hand injuries.
   
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface.
Take care not to bend or scratch the trim and panels.
1.
Loosen the mounting screw and seperate the sunvisor (A).

2.
Loosen the mounting screws and remove the retainer (A).

3.
To intall, reverse the removal procedure.
   
Replace any damaged clips (or pin-type retainers).
Sunvisor Components and Components Location
Component Location 1. Sunvisor2. Retainer ...

Assist Handle Components and Components Location
Component Location 1. Assist handle ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Radiator Repair procedures
Inspection Radiator Cap Testing 1. Remove the radiator cap, wet its seal with engine coolant, and then install it on a pressure tester. 2. Apply a pressure of 93.16 ~ 122.58 kPa (0.95 ~ 1.25 kgf/cm?, 13.51 ~ 17.78 psi). 3. Check for a drop in pressure. 4. If the pressure drops, re ...

Hyundai Elantra AD (2016-2020) Service Manual: 35R Clutch Control Solenoid Valve(35R/C_VFS) Description and Operation
Description • 35R Clutch control solenoid valve(35R/C) is attached to the valve body. • This variable force solenoid valve directly controls the hydraulic pressure inside the 35R clutch. ...

© 2018-2025 www.helantraad.com