Hyundai Elantra: General Information / Special Service Tools

Special Service Tools
Tool (Number and Name)
Illustration
Use
Deployment tool
0957A-34100A

Airbag deployment tool.
Use with (0957A-AL140, 0957A-AL150, 0957A-AL160)
Dummy
0957A-38200

Simulator to check the resistanceof each wiring harness.
Use with (0957A-AL170, 0957A-AL180, 0957A-AL190)
Airbag deployment & dummy adapter kit
0957A-AL100

Use with airbag deployment and airbag inspection
Deployment adapter
0957A-AL140

Use with deployment tool. (0957A-34100A)
(DAB, PAB, CAB, BPT, EFD)
Deployment adapter
0957A-AL150

Use with deployment tool. (0957A-34100A)
(KAB)
Deployment adapter
0957A-AL160

Use with deployment tool. (0957A-34100A)
(SAB)
Dummy adapter
0957A-AL170

Use with dummy (0957A-38200)
(DAB, PAB, CAB, BPT, EFD)
Dummy adapter
0957A-AL180

Use with dummy (0957A-38200)
(KAB)
Dummy adapter
0957A-AL190

Use with dummy (0957A-38200)
(SAB)

DAB : Driver Airbag
PAB : Passenger Airbag
SAB : Side Airbag
CAB : Curtain Airbag
KAB : Knee Air Bag
BPT : Seat Belt Pretensioner
EFD : Emergensy Fastening Devise
Specifications
Specification ItemResistance (?)Driver Airbag (DAB)1.7 ~ 6.0Passenger Airbag (PAB)1.7 ~ 6.0Knee Airbag (KAB)1.7 ~ 6.0Side Airbag (SAB)1.8 ~ 6.0Curtain Airbag (CAB)1.7 ~ 6.0Seat Belt Pretensioner ...

General Safety Information and Caution
Precautions General Precautions Please read the following precautions carefully before performing the airbag system service. Observe the instructions described in this manual, or the airbags cou ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Engine Control Module (ECM) Schematic Diagrams
ECM Terminal And Input/Output signal Harness Connector ECM Terminal Function Connector [C300-A] Pin No.DescriptionConnected to1- 2ETC Motor [+] control outputETC Motor3- 4Motor [-] control outputVariable Charge Motion Actuator (VCMA)5- 6- 7- 8- 9- 10Clutch switch signal input [M/T]Clutch s ...

Hyundai Elantra AD (2016-2020) Service Manual: Smart Key Unit Repair procedures
Removal Smart Key Unit 1. Disconnect the negative (-) battery terminal. 2. Remove the glove box. (Refer to Body - "Glove Box Upper Cover Assembly") 3. Remove the smart key unit (A) after disconnecting the connectors (B) and loosening the bolt and nut. Interior 1 Antenna   ...

В© 2018-2026 www.helantraad.com