Hyundai Elantra: Conventional Cluster / Service information
If the remaining mileage or time reaches 900 miles (1,500 km) or 30 days, the
service symbol (
) will blink for several
seconds each time you set the ignition switch or Engine Start/Stop button to the
ON position.
Information
To change or deactivate the service interval, consult an authorized HYUNDAI dealer.
If you exceed the specified service interval, the service symbol (
)
will blink each time you turn ON the vehicle.
To reset the service interval, press the RESET button for more than 5 seconds and then when the miles and days blink press the RESET button for more than 1 second.
If the service interval is not set, the service symbol (
)
will not be displayed.
Trip A/B
Tripmeter (1)
The tripmeter is the total driving distance since the last tripmeter reset.
- Distance range: 0.0 ~ 9999.9 mi. or km
To reset the tripmeter, press the RESET button on the steer ...
Digital speedometer
This message shows the speed of the vehicle (in mph).
To turn the digital speedometer ON and OFF press the RESET button for more than
1 second when the digital speedometer is displayed. ...
Other information:
Hyundai Elantra AD (2016-2020) Service Manual: Engine Control Module (ECM) Schematic Diagrams
ECM Terminal And Input/Output signal
Harness Connector
ECM Terminal Function
Connector [C300-A]
Pin No.DescriptionConnected to1- 2ETC Motor [+] control outputETC Motor3- 4Motor [-] control outputVariable Charge Motion Actuator (VCMA)5- 6- 7- 8- 9- 10Clutch switch signal input [M/T]Clutch s ...
Hyundai Elantra AD (2016-2020) Owners Manual: Limitations of the System
The Forward Collision Avoidance Assist (FCA) system is designed to monitor the
vehicle ahead or a pedestrian on the roadway through radar signals and camera recognition
to warn the driver that a collision is imminent, and if necessary, apply emergency
braking.
In certain situations, the radar ...
