Hyundai Elantra: Sunroof / Repair procedures

Hyundai Elantra AD (2016-2020) Service Manual / Body (Interior and Exterior) / Sunroof / Repair procedures

Adjustment

Inspect Glass Alignment

Inspect the step height between the roof panel (A) and the glass weatherstrip (B) and then adjust it if necessary.

Alignment adjustment

Standard value [mm(in.)]

(1) Front edge : 0 mm (0 in.)

(2) Rear edge : 0 mm (0 in.)

(3) Side edge : 0 mm (0 in.)

2.	Adjust the height of the glass by slighly loosening the screws (A).

When To Initialize The Motor

1.	After initial vehicle assembly.

2.	If the initial value is erased or damaged because of short power electric discharge during operation.

3.	After using the manual handle.

Operating The Sunroof Emergency Handle

1.	Use the sunroof emergency handle to close or open the sunroof manually if the sunroof cannot be closed electronically due to motor or controller electrical malfunction.

If needed, initialize the sunroof according to the initialization method.

Whenever the vehicle battery is disconnected or discharged, or you use the emergency handle to operate the sunroof, you have to reset your sunroof system as follows :

(1)	Turn the ignition key to the ON position and then close the sunroof completely.

(2)	Release the sunroof control lever.

(3)	Press and hold the CLOSE button for more than 10 seconds until the sunroof closed and it has moved slightly.

(4)	Release the sunroof control lever.

(5)

Press and hold the CLOSE button once again within 3 seconds until the sunroof does as follows:

A.	Tilt down > Slide Open > Slide Close

Then release the lever.

(6)	Reset procedure of sunroof system is finished.

Components and Components Location

Components 1. Glass panel assembly2. Deflector3. Motor assembly4. Spring base assembly5. Plate rail assembly6. Guide rail assembly7. Drip link rail8. Seal tape9. Frame sub assembly10. Stopper11. ...

Sunroof Glass Components and Components Location

Components Location 1. Sunroof glass ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Repair procedures
Removal 1. Remove the front bumper cover. (Refer to Body - "Front Bumper Cover") 2. Remove the high pitch horn and low pitch horn after disconnect the horn connector (A) and loosening the mounting the bolt. [Low Pitch Horn] [High Pitch Horn] Installation 1. Install the horns after ...

Hyundai Elantra AD (2016-2020) Service Manual: Troubleshooting
?Fault Diagnosis Features a fail-safe mechanism that provides "limp-home" 4th gear hold to enable the vehicle to be driven to the owner's home or dealer shop. • Fail-Safe : The TCM provides 4th gear hold and Reverse gear in the event of a malfunction. • Lim ...