Hyundai Elantra: Crankcase Emission Control System / Repair procedures

Inspection
1.
After disconnecting the vapor hose from the PCV valve, remove the PCV valve.
2.
Reconnect the PCV valve to the vapor hose.
3.
Run the engine at idle, then put a finger over the open end of the PCV valve and make sure that intake manifold vacuum can be felt.
   
The plunger inside the PCV valve will move back and forth at vacuum.

4.
If the vacuum is not felt inspect PCV operation, if operating correctly clean or replace the vapor hose.
Schematic Diagrams
Schematic Diagram ...

Positive Crankcase Ventilation (PCV) Valve Description and Operation
Operation Principle ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Accelerator Pedal Repair procedures
Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the accelerator position sensor connector (A). 3. Remove the installation nuts (A) and then remove the accelerator pedal module. Installation 1. Installation is reverse of removal. ...

Hyundai Elantra AD (2016-2020) Service Manual: Components and Components Location
Components Location 1. PCV valve2. Canister3. Purge control solenoid valve (PCSV)4. Fuel tank pressure sensor (FTPS)5. Canister close valve (CCV)6. Fuel level sensor (FLS)7. Fuel tank air filter8. Catalytic converter 1. PCV Valve2. Canister3. Purge Control Solenoid Valve (PCSV)4. Fue ...

© 2018-2025 www.helantraad.com