Hyundai Elantra: Interior Trim / Rear Transverse Trim Repair procedures

Hyundai Elantra AD (2016-2020) Service Manual / Body (Interior and Exterior) / Interior Trim / Rear Transverse Trim Repair procedures

Replacement

•	Put on gloves to prevent hand injuries.

•	When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

•	When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Remove the luggage boad (A).

2.	Remove the tail gate weatherstrip.

3.	Loosen the mounting clips and remove the rear transverse trim (A).

To intall, reverse the removal procedure.

•	Replace any damaged clips (or pin-type retainers).

Rear Transverse Trim Components and Components Location

Component Location 1. Rear transverse trim ...

Luggage Side Trim Components and Components Location

Component Location 1. Luggage side trim ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Shift Lever Components and Components Location
Components Location 1. Shift lever knob & boots2. Shift lever assembly3. Shift cable4. Manual control lever5. Shift cable retainer6. Snap pin ...

Hyundai Elantra AD (2016-2020) Service Manual: Drive Belt Repair procedures
Removal 1. Remove the drive belt. (1) Using the wrench, turning the drive belt tensioner (A) counterclockwise. (2) Disconnect the drive belt (A). (3) Remove the drive belt tensioner (A) and then remove the drive belt (B). Inspection 1. Check belt for maintenance and abnormal wea ...