Hyundai Elantra: Front Door / Front Door Latch Repair procedures

Hyundai Elantra AD (2016-2020) Service Manual / Body (Interior and Exterior) / Front Door / Front Door Latch Repair procedures

Replacement

1.	Remove the front door module. (Refer to Front Door - "Front Door Module")

2.	Remove the front door inside handle cage (A).

3.	Disconnect the front door latch connector (A).

4.	Remove the front door latch assembly (A) by pulling it in the direction of the arrow.

5.	To remove the front door outside handle base connector (A), widen both sides of the wiring fastener and then push back the front door outside handle base connector.

6.	Remove the front door outside handle connector wiring harness (A).

7.	Remove the front door outside handle base (A) by pushing in the lock pins located in the back.

8.	Remove the front door outside handle cable (A).

To intall, reverse the removal procedure.

•	Make sure the connector is connected properly.

•	Make sure the door locks / unlocks and opens / closes properly.

•	Replace any damaged clips (or pin-type retainers).

Front Door Latch Components and Components Location

Component Location 1. Front door latch ...

Rear Door

...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Photo Sensor Repair procedures
Inspection 1. Turn the ignition switch ON. 2. Connect the GDS. 3. Emit intensive light toward the photo sensor using a lamp, and check the output voltage change. 4. The voltage will rise with higher intensive light and reduce with lower intensive light. 1. Auto light signal2. Auto ...

Hyundai Elantra AD (2016-2020) Service Manual: Cylinder Head Cover Repair procedures
Removal • Use fender covers to avoid damaging painted surfaces. • To avoid damage, unplug the wiring connectors carefully while holding the connector portion. • Mark all wiring and hoses to avoid misconnection. 1. Remov ...