Hyundai Elantra: Body (Interior and Exterior) / Trunk Trim. Repair procedures

Repair procedures

Replacement
   
•
Put on gloves to prevent hand injuries.
   
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the rear seat cushion assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
2.
Remove the rear seat back assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
3.
Remove the rear door scuff trim.
(Refer to Interior Trim - "Door Scuff Trim")
4.
After loosening the mounting screws, then remove the partition center trim (A).
5.
Remove the luggage covering mat (B).
6.
Remove the rear transverse trim (C).
7.
Remove the rear wheel house trim (D).
8.
After loosening the mounting screws, remove the luggage side trim (E).
9.
To intall, reverse the removal procedure.
   
•
Replace any damaged clips.
[Folding type]

1. Rear transverse trim
2. Luggage covering mat
3. Fire extinguisher
4. Luggage net
5. Luggage side trim [LH]
6. Luggage side trim [RH]
7. Rear package tray trim
8. Rear wheel house trim [LH]
9. Rear wheel house trim [RH]
10. Partition center trim

[Bench type]

1. Rear transverse trim
2. Luggage covering mat
3. Fire extinguisher
4. Luggage net
5. Luggage side trim [LH]
6. Luggage side trim [RH]
7. Rear package tray trim
8. Rear wheel house trim [LH]
9. Rear wheel house trim [RH]
10. Partition center trim

Rear Package Tray Trim Repair procedures
Replacement     • Put on gloves to prevent hand injuries.     • When removing with a flat-tip screwdriver or remover, wrap protective tape around ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Driver Airbag (DAB) Module and Clock Spring Components and Components Location
Components 1. Driver Air Bag (DAB)2. Steering Wheel3. Clock Spring ...

Hyundai Elantra AD (2016-2020) Service Manual: Description and Operation
Description The starting system includes the battery, starter, solenoid switch, ignition switch, inhibitor switch (A/T), clutch pedal switch (M/T), ignition lock switch, connection wires and the battery cable. When the ignition key is turned to the start position, current flows and energizes ...

© 2018-2026 www.helantraad.com