Hyundai Elantra: Trunk Trim / Repair procedures

Replacement
   
•
Put on gloves to prevent hand injuries.
   
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the rear seat cushion assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
2.
Remove the rear seat back assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
3.
Remove the rear door scuff trim.
(Refer to Interior Trim - "Door Scuff Trim")
4.
After loosening the mounting screws, then remove the partition center trim (A).
5.
Remove the luggage covering mat (B).
6.
Remove the rear transverse trim (C).
7.
Remove the rear wheel house trim (D).
8.
After loosening the mounting screws, remove the luggage side trim (E).
9.
To intall, reverse the removal procedure.
   
•
Replace any damaged clips.
[Folding type]

1. Rear transverse trim
2. Luggage covering mat
3. Fire extinguisher
4. Luggage net
5. Luggage side trim [LH]
6. Luggage side trim [RH]
7. Rear package tray trim
8. Rear wheel house trim [LH]
9. Rear wheel house trim [RH]
10. Partition center trim

[Bench type]

1. Rear transverse trim
2. Luggage covering mat
3. Fire extinguisher
4. Luggage net
5. Luggage side trim [LH]
6. Luggage side trim [RH]
7. Rear package tray trim
8. Rear wheel house trim [LH]
9. Rear wheel house trim [RH]
10. Partition center trim

Trunk Trim
...

Windshield Glass
...

Other information:

Hyundai Elantra AD (2016-2020) Owners Manual: Power Brakes
Your vehicle has power-assisted brakes that adjust automatically through normal usage. If the engine is not running or is turned off while driving, the power assist for the brakes will not work. You can still stop your vehicle by applying greater force to the brake pedal than typical. The sto ...

Hyundai Elantra AD (2016-2020) Service Manual: Cylinder Head Cover Repair procedures
Removal     • Use fender covers to avoid damaging painted surfaces. • To avoid damage, unplug the wiring connectors carefully while holding the connector portion.     • Mark all wiring and hoses to avoid misconnection. 1. Remov ...

© 2018-2025 www.helantraad.com