Hyundai Elantra: Floor Console / Rear Console Cover Repair procedures

Replacement
   
•
Put on gloves to prevent hand injuries.
   
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the floor console assembly.
(Refer to Floor Console - "Floor Console Assembly")
2.
Loosen the rear console mounting screws.

3.
Using a screwdriver or remover, remove the rear console cover (A).

4.
To intall, reverse the removal procedure.
   
•
Make sure the connector is connected properly.
•
Replace any damaged clips (or pin-type retainers).
Rear Console Cover Components and Components Location
Component Location 1. Rear console cover ...

Console Armrest Components and Components Location
Component Location 1. Console armrest ...

Other information:

Hyundai Elantra AD (2016-2020) Owners Manual: Driving Your Vehicle
WARNING Carbon monoxide (CO) gas is toxic. Breathing CO can cause unconsciousness and death. Engine exhaust contains carbon monoxide which cannot be seen or smelled. Do not inhale engine exhaust. If at any time you smell engine exhaust inside the vehicle, open the windows immediately. Exposu ...

Hyundai Elantra AD (2016-2020) Service Manual: Components and Components Location
Components 1. Camshaft bearing cap2. Camshaft front bearing cap3. Exhaust camshaft4. Intake camshaft5. Exhaust CVVT assembly6. Intake CVVT assembly7. Cam carrier8. Cylinder head9. Cylinder head gasket10. Retainer lock11. Retainer 12. Valve spring13. Valve stem seal14. Valve 15. Swing arm16. Hyd ...

© 2018-2025 www.helantraad.com