Hyundai Elantra: Front Bumper / Radiator Grill Repair procedures

Replacement
   
Put on gloves to prevent hand injuries.
   
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
Take care not to bend or scratch the trim and panels.
1.
Remove the front bumper cover.
(Refer to Front Bumper - "Front Bumper Cover")
2.
Separate the front bumper wiring (A).

3.
Remove the fixing clip and then the front bumper energy absorber (A).

4.
Using a screwdriver or remover, remove the radiator grill cover (A).

5.
Loosen the radiator grill mounting screws.
6.
Using a screwdriver or remover, pull the clip upward and remove the radiator grill (A).

7.
To intall, reverse the removal procedure.
   
Replace any damaged clips (or pin-type retainers).
Radiator Grill Components and Components Location
Component Location 1. Radiator grill ...

Rear Bumper
...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Temperature Control Actuator Specifications
Specifications Door PositionVoltage (V)Error DetectingMax. cooling0.3 ± 0.15 Low voltage : 0.1V or less High voltage : 4.9V or moreMax. heating4.7 ± 0.15 ...

Hyundai Elantra AD (2016-2020) Service Manual: AVN(Audio Video Navigation) head unit Components and Components Location
Components Connector Pin Information NoConnector AConnector BConnector C1-Multmedia-CAN (High)Chassis-CAN (Low)2--Chassis-CAN (High)3---4-Steering wheel remote controller-5SPDIF Shield GND--6SPDIF (+)MTS keypad signal-7---8Illumination (+)AUX R input-9-Multimedia jack (GND)- 10-MIC (+)-11-Batt ...

© 2018-2025 www.helantraad.com