Inspection |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the front door quadrant inner cover (A). |
3. |
Disconnect the power door mirror connector from the harness. |
4. |
Apply battery voltage to each terminal as shown in the table and verify that the mirror operates properly.
[Mirror Control (LH/RT)]
[Puddle Lamp]
[BSD Indicator]
[Mirror Heater]
[Side Repeater Lamp] |
Hyundai Elantra AD (2016-2020) Service Manual: Immobilizer Control Unit Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the main crash pad assembly.
(Refer to Body - "Main Crash Pad Assembly")
3.
Discnnect the connector of the immobilizer unit and then remove the immobilizer unit (A) after loosening a nut.
Installation
1.
Install the ...
Hyundai Elantra AD (2016-2020) Service Manual: Rear Door Latch Components and Components Location
Component Location
1. Rear door latch
...