Hyundai Elantra: Automatic Transaxle Control System / Output Speed Sensor Description and Operation

Description
The output speed sensor is a vital unit that measures the rate of rotation of the transaxle's turbine shaft and output shaft, and delivers the readings to the TCM. The sensor provides critical input data that's used in feedback control, damper clutch control, gear setting control, line pressure control, clutch activation pressure control, and sensor fault analysis.

Input Speed Sensor Repair procedures
Inspection 1. Using the GDS, check the input/output speed sensor waveforms. A. Turn OFF the ignition switch. B. Connect the GDS to the Data Link Connector(DLC) on the lower crash pad. C. ...

Output Speed Sensor Specifications
Specifications ? Type: Hall effect sensor ? Specifications ItemsSpecificationsOperation condition [°C(°F)](-40 ~ 150) -40 ~ 302Output voltage(V)High1.18 ~ 1.68Low0.59 ~ 0.84 ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Cylinder Head Repair procedures
Removal Engine removal is not required for this procedure.     • Use fender covers to avoid damaging painted surfaces. • To avoid damaging the cylinder head, wait until the engine coolant temperature drops below normal temperature (20°C [68°F]) before removin ...

Hyundai Elantra AD (2016-2020) Service Manual: External AMP Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Open the trunk, remove the right luggage side trim. (Refer to Body - "Trunk Trim") 3. Remove the external amplifier (B) after disconneting the connector (A) and loosening the mounting nuts. Installation 1. Install the exte ...

© 2018-2026 www.helantraad.com