Hyundai Elantra: Lubrication System / Oil Level Gauge & Pipe Repair procedures

Removal and Installation
1.
Remove the oil level gauge (A).

2.
Install in the reverse order of removal.
Oil Pressure Switch Repair procedures
Removal and Installation 1. Disconnect the oil pressure switch connector (A) and then remove the oil pressure switch (B). Tightening torque : 9.8 ~ 11.8N.m (1.0 ~ 1.2kgf.m, 7.2 ~ 8.7lb-ft) ...

Intake And Exhaust System
...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Rear Back Armrest Repair procedures
Replacement     • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. • Use a plastic panel removal tool to remove interior trim pieces without marring the surface. • Take care not to ...

Hyundai Elantra AD (2016-2020) Service Manual: Output Speed Sensor Repair procedures
Inspection 1. Using the GDS, check the input/output speed sensor waveforms. A. Turn OFF the ignition switch. B. Connect the GDS to the Data Link Connector(DLC) on the lower crash pad. C. Ignition "ON" & Engine "ON". D. Check the input/output speed sensor waveforms at high spe ...

© 2018-2022 www.helantraad.com