Hyundai Elantra: Engine Control System / Knock Sensor (KS) Repair procedures

Hyundai Elantra AD (2016-2020) Service Manual / Engine Control/Fuel System / Engine Control System / Knock Sensor (KS) Repair procedures

Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Disconnect the knock sensor connector (A).

3.	Remove the intake manifold. (Refer to Engine Mechanical System - "Intake Manifold")

4.	Remove the installation bolt (A), and then remove the sensor from the cylinder block.

Installation

•	Install the component with the specified torques.

•	Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.

Installation is reverse of removal.

Knock sensor installation bolt :

18.6 ~ 23.5 N.m (1.9 ~ 2.4 kgf.m, 13.7 ~ 17.4 lb-ft)

Knock Sensor (KS) Schematic Diagrams

Circuit Diagram ...

Heated Oxygen Sensor (HO2S) Description and Operation

Description Heated Oxygen Sensor (HO2S) consists of zirconium and alumina and is installed both upstream and downstream of the Catalytic Converter. It varies in accordance with the air/fuel rat ...

Other information:

Hyundai Elantra AD (2016-2020) Owners Manual: Aluminum wheel maintenance
The aluminum wheels are coated with a clear protective finish. NOTICE Do not use abrasive cleaner, polishing compound, solvent, or wire brushes on aluminum wheels. Clean the wheel when it has cooled. Use only a mild soap or neutral detergent, and rinse thoroughly with water. Also, cle ...

Hyundai Elantra AD (2016-2020) Service Manual: Warning And Caution Labels
General Information 1. Radiator cap caution2. Fan caution3. Battery caution Attention Srs VehicleThis car is equipped with a supplemental restraint system. To provide continued reliability, certain elements of the supplemental restraint system shall be serviced or replaced by an aut ...