Hyundai Elantra: Blower / Intake Actuator Specifications
| Specifications |
| Door position | Voltage (V) | Error detecting |
| Max. cooling | 0.3 ± 0.15 | Low voltage : 0.1V or less |
| Max. heating | 4.7 ± 0.15 | High voltage : 4.9V or more |
Intake Actuator Description and Operation
Description
The intake actuator is located at the blower unit. It
regulates the intake door by a signal from the control unit. Pressing
the intake selection switch will shift between recirculat ...
Intake Actuator Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the intake actuator connector.
3.
Verify that the intake actuator operates to the fresh position when connecting 12V to terminal 3 ...
Other information:
Hyundai Elantra AD (2016-2020) Service Manual: Rear Door Belt Outside Weatherstrip Repair procedures
Replacement
1.
Pull down the rear door window glass to the lowest level by pressing the power window glass switch.
2.
After loosening the mounting screws, remove the rear door belt outside weatherstrip (A).
3.
To intall, reverse the removal procedure.
•
Replac ...
Hyundai Elantra AD (2016-2020) Service Manual: Crankcase Emission Control System
Schematic Diagrams
Schematic Diagram
Repair procedures
Inspection
1.
After disconnecting the vapor hose from the PCV valve, remove the PCV valve.
2.
Reconnect the PCV valve to the vapor hose.
3.
Run the engine at idle, then put a finger over the open end
of the PCV valve and make ...
