Immobilizer Indicator Light (without smart key)

This indicator light illuminates:
• When the vehicle detects the immobilizer in the key with the ignition switch in the ON position.
- At this time, you can start the engine.
- The indicator light goes off after starting the engine.
This indicator light blinks:
• When there is a malfunction with the immobilizer system.
In this case, have the vehicle inspected by an authorized HYUNDAI dealer.
Immobilizer Indicator Light (with smart key)

This indicator light illuminates for up to 30 seconds:
When the vehicle detects the smart key in the vehicle with the Engine Start/Stop button in the ACC or ON position.
- At this time, you can start the engine.
- The indicator light goes off after starting the engine.
This indicator light blinks for a few seconds:
When the smart key is not in the vehicle.
- At this time, you cannot start the engine.
This indicator light illuminates for 2 seconds and goes off:
If the smart key is in the vehicle and the Engine Start/Stop button is ON, but the vehicle cannot detect the smart key.
In this case, have your vehicle inspected by an authorized HYUNDAI dealer.
This indicator light blinks:
• When there is a malfunction with the immobilizer system.
In this case, have your vehicle inspected by an authorized HYUNDAI dealer.
Electronic Stability Control (ESC) OFF Indicator Light
Turn Signal, High Beam, Light ON Indicator LightsHyundai Elantra AD (2016-2020) Service Manual: Output Speed Sensor Description and Operation
Description
The output speed sensor is a vital unit that measures the
rate of rotation of the transaxle's turbine shaft and output shaft, and
delivers the readings to the TCM. The sensor provides critical input
data that's used in feedback control, damper clutch control, gear
setting co ...
Hyundai Elantra AD (2016-2020) Service Manual: Repair procedures
Removal
•
Put on gloves to protect your hands.
•
Use seat covers to avoid damaging any surfaces.
1.
Remove the roof side molding.
(Refer to Body Side Moldings - "Roof Side Molding")
2.
Remove the package tray trim.
(Refer to ...