Hyundai Elantra: Anti-lock Brake System (ABS) Warning Light, Electronic Brake Force Distribution (EBD) System Warning Light / Turn Signal, High Beam, Light ON Indicator Lights

Turn Signal Indicator Light

Hyundai Elantra. Turn Signal, High Beam, Light ON Indicator Lights

This indicator light blinks:

When you operate the turn signal indicator.

If any of the following occurs, there may be a malfunction with the turn signal system.

- The turn signal indicator light illuminates but does not blink
- The turn signal indicator light blinks rapidly
- The turn signal indicator light does not illuminate at all

If either of these conditions occur, have your vehicle inspected by an authorized HYUNDAI dealer.

High Beam Indicator Light

Hyundai Elantra. Turn Signal, High Beam, Light ON Indicator Lights

This indicator light illuminates:

Light ON Indicator Light

Hyundai Elantra. Turn Signal, High Beam, Light ON Indicator Lights

This indicator light illuminates:

When the tail lights or headlights are on.

Immobilizer Indicator Light
Immobilizer Indicator Light (without smart key) This indicator light illuminates: • When the vehicle detects the immobilizer in the key with the ignition switch in the ON position. - At this ...

High Beam Assist (HBA) indicator light, Cruise Indicator Light
High Beam Assist (HBA) indicator light This indicator light illuminates : When the high-Beam is on with the light switch in the AUTO light position. If your vehicle detects oncoming or preced ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Sub Frame Repair procedures
Removal 1. Loosen the wheel nuts slightly. 2. Raise the vehicle, and make sure it is securely supported. 3. Remove the front wheel and tire (A) from front hub. Tightening torque : 107.9 ~ 127.5 N.m (11.0 ~ 13.0 kgf.m, 79.6 ~ 94.0 lb-ft)     • Be careful not ...

Hyundai Elantra AD (2016-2020) Service Manual: Driver Airbag (DAB) Module and Clock Spring Repair procedures
Removal 1. Disconnect the battery negative cable and wait for at least three minutes before beginning work. 2. Remove the driver airbag module by putting in a flat tool (O5mm) into the guide hole and then press the spring. 3. Release the connector locking pin, then disconnect the driver ...

© 2018-2025 www.helantraad.com