Hyundai Elantra: Front Door / Front Door Module Repair procedures

Replacement
1.
Remove the front door window glass.
(Refer to Front Door - "Front Door Window Glass")
2.
Remove the front door outside handle.
(Refer to Front Door - "Front Door Outside Module")
3.
Loosen the front door outside handle base mounting bolt (A).

Tightening torque :
2.0 ~ 2.9 N.m (0.2 ~ 0.3 kgf.m, 1.4 ~ 2.2 lb-ft)

4.
Disconnect the front door main connector (A) and outside rear view mirror connector (B).

5.
Loosen the front door latch mounting screws.

Tightening torque :
7.8 ~ 14.7 N.m (0.8 ~ 1.5 kgf.m, 5.8 ~ 10.8 lb-ft)

6.
Loosen the mounting bolts and remove the front door module (A).

Tightening torque :
8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 8.5 ~ 10.1 lb-ft)

7.
Disconnect the connectors and front door module wiring harness (A).

8.
Remove the front door latch assembly.
(Refer to Front Door - "Front Door Latch")
9.
Reomove the front speaker.
(Refer to Body Electrical System - "Speakers")
10.
Remove the front power window motor.
(Refer to Body Electrical System - "Power Window Motor")
11.
Remove the side impact sensor.
(Refer to Restraint - "Side Impact Sensor (SIS)")
12.
To intall, reverse the removal procedure.
   
•
Make sure connectors are connected properly and each rod is connected securely.
•
Make sure the door locks / unlocks and opens / closes properly.
Front Door Module Components and Components Location
Component Location 1. Front door module ...

Front Door Outside Handle Components and Components Location
Component Location 1. Front door outside handle ...

Other information:

Hyundai Elantra AD (2016-2020) Owners Manual: Rear Seats. Armrest
Folding the rear seat The rear seatbacks can be folded to facilitate carrying long items or to increase the luggage capacity of the vehicle. WARNING Never allow passengers to sit on top of the folded down seatback while the vehicle is moving. This is not a proper seating position and no s ...

Hyundai Elantra AD (2016-2020) Service Manual: Front Driveshaft Repair procedures
Removal 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) from front hub. Tightening torque : 107.9 ~ 127.5 N.m (11.0 ~ 13.0 kgf.m, 79.6 ~ 94.0 lb-ft)     • Be careful not to dam ...

© 2018-2026 www.helantraad.com