Hyundai Elantra: Cylinder Block / Drive plate Repair procedures

Removal and Installation
1.
Remove the automatic transaxle.
(Refer to Automatic Transaxle System - "Automatic Transaxle")
2.
Remove the drive plate (A) and the adapter plate (B).

Tightening torque:
117.7 ~ 127.5 N.m (12.0 ~ 13.0 kgf.m, 86.8 ~ 94.0 lb-ft)

   
Do not reuse the bolts.
3.
Install in the reverse order of removal.
Drive plate Components and Components Location
Components 1. Adapter plate2. Drive plate ...

Rear Oil Seal Components and Components Location
Components 1. Rear oil seal ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Components and Components Location
Component Location 1. Fender assembly ...

Hyundai Elantra AD (2016-2020) Service Manual: ESC Control Unit Repair procedures
Removal 1. Turn the ignition switch OFF and then disconnect the negative (-) battery cable. 2. Pull up the lock of the HECU connector (A) , then disconnect the connector. 3. Remove the brake fluid from the master cylinder reservoir with a syringe.     • Be sure to ...

© 2018-2024 www.helantraad.com