Hyundai Elantra: Crash Pad / Center Fascia Panel Repair procedures

Hyundai Elantra AD (2016-2020) Service Manual / Body (Interior and Exterior) / Crash Pad / Center Fascia Panel Repair procedures

Replacement

•	Put on gloves to prevent hand injuries.

•	When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

•	Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

1.	Remove the cluster fascia panel. (Refer to Cluster Pad - "Center Fascia Panel")

2.	Loosen the mounting screws and remove the center fascia panel (A).

To intall, reverse the removal procedure.

•	Replace any damaged clips (or pin-type retainers).

Center Fascia Panel Components and Components Location

Components Location 1. Center fascia panel ...

Crash Pad Lower Panel Components and Components Location

Component Location 1. Crash pad lower panel ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Input Speed Sensor Repair procedures
Inspection 1. Using the GDS, check the input/output speed sensor waveforms. A. Turn OFF the ignition switch. B. Connect the GDS to the Data Link Connector(DLC) on the lower crash pad. C. Ignition "ON" & Engine "ON". D. Check the input/output speed sensor waveforms at high spe ...

Hyundai Elantra AD (2016-2020) Service Manual: Schematic Diagrams
Schematic Diagrams Terminal Function Wire No.DesignationCurrentmaxmin13Ground for recirculation pump39 A10 A1Voltage supply for pump motor39 A10 A25Voltage supply for solenoid valves15 A2 A38Ground for solenoid valves andECU15 A2 A22Signal wheel speed sensor (FL)16.8 mA5.9 mA33Voltage supply f ...