Hyundai Elantra: Audio / Audio Remote Control Repair procedures

Hyundai Elantra AD (2016-2020) Service Manual / Body Electrical System / Audio / Audio Remote Control Repair procedures

Inspection
1.
Check for resistance between terminals in each switch position (LH).

[LH : Audio + Hands free]
Switch
Connector
terminal
Resistance
(±5%)
SEEK Up
2-5
430 ?
SEEK Down
1.11 k?
MODE
2.11 k?
MUTE
3.11 k?
Volume (+)
4.61 k?
Volume (-)
6.81 k?
Voice
10.71 k?
SEND
18.91 k?
END
40.91 k?

2.
Check for resistance between terminals in each switch position (RH).

[RH : Trip + Cruise]
Switch
Connector
terminal
Resistance
(±5%)
Cancel
2-5
330 ?
SET -
550 ?
RES +
880 ?
Cruise ON/OFF
1.44 k?
Group
3-5
550 ?
Trip Up
880 ?
Trip Down
1.44 k?
ENTER
2.54 k?
SCC ON / OFF
5.54 k?

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering wheel assembly.
(Refer to Steering System - "Steering Wheel")
3.
Remove the steering back cover (A).

4.
Remove the steering remote control connector (A).

5.
Remove the steering remote control after loosening the screws.

Installation
1.
Install the steering wheel remote control after connecting the connector.
2.
Connect the negative (-) battery terminal.
Audio Remote Control Schematic Diagrams
Circuit Diagram [Audio + B/Tooth + Voice] [Trip] [Trip / Cruise] [Trip / Cruise/ Smart Cruise] ...

Multimedia Jack Schematic Diagrams
Circuit Diagram ...

Other information:

Hyundai Elantra AD (2016-2020) Owners Manual: Emergency Towing
If towing is necessary, we recommend you have it done by an authorized HYUNDAI dealer or a commercial tow truck service. If towing service is not available in an emergency, your vehicle may be temporarily towed using a cable or chain secured to the emergency towing hook at the front of the ...

Hyundai Elantra AD (2016-2020) Service Manual: Torque Converter Control Solenoid Valve (T/CON_VFS) Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the battery and battery tray. (Refer to Engine Electrical System - "Battery") 3. Disconnect the solenoid valve connector (A). 4. Measure resistance between sensor signal terminal and sensor ground terminal. 5. Check that the ...

© 2018-2025 www.helantraad.com