Hyundai Elantra: Wipers and Washers / Windshield Wipers
Operates as follows when the ignition switch is in the ON position.
MIST : For a single wiping cycle, push the lever upward and release. The wipers will operate continuously if the lever is held in this position.
OFF : Wiper is not in operation.
INT : Wiper operates intermittently at the same wiping intervals. To vary the speed setting, move the speed control lever. The top most setting will run the wipers most frequently (for more rain). The bottom setting will run the wipers the least frequently (for less rain).
LO : The wiper runs at a lower speed.
HI : The wiper runs at a higher speed.
Information
If there is heavy accumulation of snow or ice on the windshield, defrost the windshield for about 10 minutes, or until the snow and/or ice is removed before using the windshield wipers to ensure proper operation.
If you do not remove the snow and/or ice before using the wiper and washer, it may damage the wiper and washer system.
Wipers and Washers
A : Wiper speed control
· MIST – Single wipe
· OFF – Off
· INT – Intermittent wipe
· LO – Low wiper speed
· HI – High wiper speed
B : Intermittent control wipe time adjustment
...
Windshield Washers
In the OFF position, pull the lever gently toward you to spray washer fluid on
the windshield and to run the wipers 1-3 cycles. The spray and wiper operation will
continue until you release the ...
Other information:
Hyundai Elantra AD (2016-2020) Service Manual: Components and Components Location
Components
1. ABS Control Module(HECU)2. Front Wheel Speed Sensor3. Rear Wheel Speed Sensor4. ABS Warning lamp5. EBD / Parking brake warning lamp
...
Hyundai Elantra AD (2016-2020) Owners Manual: Using the Tire Mobility Kit
CAUTION
Detach the speed restriction label (1) from the sealant bottle (2), and place
it in a highly visible place inside the vehicle such as on the steering wheel to
remind the driver not to drive too fast.
1. Shake the sealant bottle (2).
2. Connect the filling hose (3) to the sealant bot ...
