Hyundai Elantra: Cooling System / Water Temperature Control Assembly Repair procedures
| Removal and Installation |
| 1. |
Remove the engine cover.
(Refer to Engine And Transaxle Assembly - “Engine Cover”) |
| 2. |
Drain the engine coolant so its level is below water temperature control assembly.
(Refer to Cooling System - "Coolant") |
| 3. |
Remove the air duct and air cleaner assembly.
(Refer to Intake And Exhaust System - “Air Cleaner”) |
| 4. |
Disconnect the radiator upper hose (A).
|
| 5. |
Disconnect the heater hoses (A).
|
| 6. |
Disconnect the bypass hose (A) and the throttle body coolant hose (B) (if equipped).
|
| 7. |
Remove the water temperature control assembly (A) with the O-ring .
|
| 8. |
Install in the reverse order of removal. |
| 9. |
Fill the engine coolant.
(Refer to Cooling System - "Coolant") |
| 10. |
Start engine and check for leaks. |
Water Temperature Control Assembly Components and Components Location
Components
1. Water temperature control assembly2. Engine coolant temperature sensor3. Throttle body coolant hose (if equipped)
...
Water pump Components and Components Location
Components
1. Water pump pulley2. Water pump3. Water pump gasket
...
Other information:
Hyundai Elantra AD (2016-2020) Service Manual: Front Rear Parking Assist System Switch Repair procedures
Removal
•
Put on gloves to prevent hand injuries.
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
Use a plastic panel removal tool to remove interior ...
Hyundai Elantra AD (2016-2020) Service Manual: Front Door Outside Handle Repair procedures
Replacement
1.
Remove the plug hole (B).
2.
After loosening the mounting bolt, remove the front door lock assembly (A).
Tightening torque :
7.8 ~ 10.8 N.m (0.8 ~ 1.1 kgf.m, 5.8 ~ 8.0 lb-ft)
3.
Remove the front door outside handle (A) by sliding it forward.
4.
Disconnect the fro ...
