Hyundai Elantra: Engine Control System / Variable Charge Motion Actuator (VCMA) Description and Operation

Hyundai Elantra AD (2016-2020) Service Manual / Engine Control/Fuel System / Engine Control System / Variable Charge Motion Actuator (VCMA) Description and Operation

Description

The Variable Charge Motion Actuator (VCMA) is installed on the inlet of the intake manifold.

It consists of a DC motor which actuates the VCM valve and a position sensor which detects the position of the VCM valve.

The VCM system tumbles air flow entering into combustion chamber of each cylinder by closing the VCM valve in the cold start conditions.

This tumble effect reduces cold start emissions by improving atomization

Canister Close Valve (CCV) Repair procedures

Inspection 1. Turn the ignition switch OFF. 2. Disconnect the CCV connector. 3. Measure resistance between the CCV terminal 1 and 2. 4. Check that the resistance is within the specific ...

Variable Charge Motion Actuator (VCMA) Components and Components Location

Components 1. Coupling2. Shaft3. Stabilizer O-ring4. Stabilizer5. O-ring6. Insert nut7. Stabilizer Cover8. Valve9. Hole cover ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the battery and battery tray. (Refer to Engine Electrical System - "Battery") 3. Disconnect the solenoid valve connector (A). 4. Measure resistance between sensor signal terminal and sensor ground terminal. 5. Check that the ...

Hyundai Elantra AD (2016-2020) Service Manual: Door Scuff Trim Repair procedures
Replacement [Front door scuff trim] • Put on gloves to prevent hand injuries. • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. • When removing the i ...