Hyundai Elantra: Automatic Transaxle Control System / SS-A Solenoid Valve(ON/OFF) Description and Operation
| Description |
| • |
SS-A solenoid valve is attached to the valve body and is an on/off solenoid valve that is used to change gears. |
| • |
SS-A Solenoid valve(ON/OFF) is installed at valve body.
|
Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
3.
Disconnect the solenoid valve connector (A).
4.
M ...
SS-A Solenoid Valve(ON/OFF) Specifications
Specifications
? Control type : Normally low type
ShapeItems Specifications Control current(voltage) [V] 9 ~ 16 Supply pressure [kpa (kgf/cm?, psi)] 490.33 (5.0, 71.12) Control pr ...
Other information:
Hyundai Elantra AD (2016-2020) Service Manual: Front Door Belt Inside Weatherstrip Repair procedures
Replacement
1.
Remove the front door trim.
(Refer to Front Door - "Front Door Trim")
2.
Remove the front door belt inside weatherstrip (A).
3.
To intall, reverse the removal procedure.
•
When installing, install it by first contacting the inside part (basis p ...
Hyundai Elantra AD (2016-2020) Service Manual: Crankshaft Position Sensor (CKPS) Repair procedures
Inspection
1.
Check signal waveform of CKPS and CMPS using a scan tool.
Specification : Refer to "Waveform"
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the crankshaft position sensor connector (A) and remove the sensor af ...
