Hyundai Elantra: General Information / Specifications
| Specification |
Air Conditioner
| Item | Specification | |
| Compressor | Type | 6VSe14 |
| Oil type & Capacity | FD46XG (IDEMITSU) 110 ± 10 g (3.88 ± 0.35 oz.) | |
| Pulley type | 6PK-TYPE | |
| Displacement | 142 cc/rev | |
| Expansion valve | Type | Block type |
| Refrigerant | Type | R-134a |
| Capacity | 500 ± 25 g (17.6 ± 0.88 oz.) | |
Blower Unit
| Item | Specification | |
| Fresh and recirculation | Operating method | Actuator |
| Blower | Type | Sirocco pan |
| Speed step | Auto + 8 speed (Automatic), 1 ~ 4 speed (Manual) | |
| Speed control | Power mosfet (Automatic), Resistor (Manual) | |
| Air filter | Type | Particle filter |
Heater and Evaporator Unit
| Item | Specification | |||
| Heater | Type | Fin & Tube type | ||
| Type | Tube - Fin 1Way | |||
| Mode operating method | Actuator | |||
| Temperature operating method | Actuator | |||
| Evaporator | Temperature control type | Evaporator temperature sensor | ||
| Blower singular | A/C Output OFF Temperature | A/C Output ON Temperature | ||
| Manual control | 1 ~ 2 speed | 1.5°C (34.7°F) | 3.0°C (37.4°F) | |
| 3 ~ 4 speed | 0.6°C (33.1°F) | 2.1°C (35.8°F) | ||
| Dual control | 1 ~ 4 speed | 1.5°C (34.7°F) | 3.0°C (37.4°F) | |
| 5 ~ 6 speed | 1.0°C (33.8°F) | 2.5°C (36.5°F) | ||
| 7 ~ 8 speed | 0.6°C (33.1°F) | 2.1°C (35.8°F) | ||
| Manufacturer | HVCC (Halla Visteon Climate Control) | |||
| Tightening Torques |
| Items | N.m | kgf.m | lb-ft |
| Compressor | 20.0 ~ 32.95 | 2.04 ~ 3.36 | 14.75 ~ 24.30 |
| Condenser - Discharge hose | 8.8 ~ 13.7 | 0.9 ~ 1.4 | 6.5 ~ 10.1 |
| Condenser - Liquid tube | |||
| Compressor - Discharge hose | 21.6 ~ 32.4 | 2.2 ~ 3.3 | 15.9 ~ 23.9 |
| Compressor - Suction hose | |||
| Expansion valve - Evaporator | 7.8 ~ 11.8 | 0.8 ~ 1.2 | 5.8 ~ 8.7 |
Troubleshooting
Troubleshooting
Problem Symptoms Table
Before replacing or repairing air conditioning components,
first determine if the malfunction is due to the refrigerant charge, air
flow or compressor. ...
Other information:
Hyundai Elantra AD (2016-2020) Service Manual: Passenger Airbag (PAB) Module Repair procedures
Removal
1.
Disconnect the battery negative cable and wait for at least three minutes before beginning work.
2.
Remove the glove box housing.
(Refer to Body - "Glove Box Upper Cover Assembly")
3.
Remove the passenger airbag mounting bolts.
4.
Disconnect the passenger airbag connector ...
Hyundai Elantra AD (2016-2020) Service Manual: Rear Pillar Trim Repair procedures
Replacement
•
Put on gloves to prevent hand injuries.
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
When removing the interior trim pieces, use a ...
© 2018-2023 www.helantraad.com
