Hyundai Elantra: Airbag Module / Side Airbag (SAB) Module Repair procedures

Hyundai Elantra AD (2016-2020) Service Manual / Restraint / Airbag Module / Side Airbag (SAB) Module Repair procedures

Removal

•	The side airbag cannot be disassembled from the seat back assembly, so replace the seat back assembly when replacing the side airbag.

1.	Disconnect the battery negative cable and wait for at least 3 minutes before beginning work.

2.	Remove the front seat assembly. (Refer to Body - "Front Seat Assembly")

3.	Remove the seat back cover. (Refer to Body - "Front Seat Back Cover")

4.	Remove the side airbag (A) after loosening the side airbag mounting nuts.

Installation

•	Be sure to install the harness wires so they will not pinch or interfere with other parts.

•	Do not open the lid of the side airbag cover.

•	Make sure that the airbag assembly cover is installed properly. Improper installation may prevent the proper deployment.

1.	Remove the ignition key from the vehicle.

2.	Disconnect the battery negative cable and wait for at least three minutes.

3.	Install the front seat back cover. (Refer to Body - "Front Seat Back Cover")

4.	Install the front seat assembly. (Refer to Body - "Front Seat Assembly")

5.	Recline and slide the front seat forward fully, make sure the harness wires are not pinched of interfere with other parts.

6.	Reconnect the battery negative cable.

After installing the side airbag (SAB), confirm proper system operation :

A.	Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

Side Airbag (SAB) Module Description and Operation

Description The Side Airbags (SAB) are installed inside the front seat and protects the driver and passenger from danger when side crash occurs. The SRSCM determines deployment of side airbag b ...

Curtain Airbag (CAB) Module Components and Components Location

Components 1. Curtain Air Bag (CAB) ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Horn
Components and Components Location Component Location 1. Horn switch2. Horn relay (Built - in PCB Block)3. Horn (Low pitch)4. Horn (High pitch)5. Clock spring Repair procedures Removal 1. Remove the front bumper cover. (Refer to Body - "Front Bumper Cover") 2. Remove the high pitch ...

Hyundai Elantra AD (2016-2020) Service Manual: Center Fascia Panel Repair procedures
Replacement • Put on gloves to prevent hand injuries. • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. • Use a plastic panel removal tool to remove int ...