Front seat warmers (if equipped)
Seat warmers are provided to warm the seats during cold weather.
WARNING
The seat warmers can cause a SERIOUS BURN, even at low temperatures and especially if used for long periods of time. Passengers must be able to feel if the seat is becoming too warm so they can turn it off, if needed.
People who cannot detect temperature change or pain to the skin should use extreme caution, especially the following types of passengers:
WARNING
NEVER place anything on the seat that insulates against heat when the seat warmer is in operation, such as a blanket or seat cushion. This may cause the seat warmer to overheat, causing a burn or damage to the seat.
NOTICE
To prevent damage to the seat warmers and seats:
While the engine is running, push either of the switches to warm the driver's seat or front passenger's seat.
During mild weather or under conditions where the operation of the seat warmer is not needed, keep the switches in the OFF position.
• Manual temperature control
Each time you push the switch, the temperature setting of the seat is changed as follows :
• Automatic temperature control The seat warmer starts to automatically control the seat temperature in order to prevent low-temperature burns after being manually turned ON.
If HIGH temperature is manually selected again, the temperature will be controlled automatically.
• When pressing the switch for more than 1.5 seconds with the seat warmer operating, the seat warmer will turn OFF.
• The seat warmer defaults to the OFF position whenever the ignition switch is in the ON position.
Information
With the seat warmer switch in the ON position, the heating system in the seat turns off or on automatically depending on the seat temperature.
Hyundai Elantra AD (2016-2020) Service Manual: Alternator Components and Components Location
Components
1. OAD (Overrunning Alternator Decoupler) 2. Front Bracket3. Front Bearing4. Stator5. Rotor6. Rear Bearing7. Rear Bracket8. Brush Holder Assembly9. Through Bolt10. Rectifier Assembly11. Rear Cover
...
Hyundai Elantra AD (2016-2020) Service Manual: Front Disc Brake Repair procedures
Removal
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the front wheel and tire (A) from front hub .
Tightening torque:
107.9 ~ 127.5 N.m (11.0 ~ 13.0 kgf.m, 79.6 ~ 94.0 lb-ft)
•
Be careful not to da ...