Hyundai Elantra: Safety System of Your Vehicle / Seat Belts

This section describes how to use the seat belts properly. It also describes some of the things not to do when using seat belts.

Seat Belt Safety Precautions

Always fasten your seat belt and make sure all passengers have fastened their seat belts before starting any trip. Air bags are designed to supplement the seat belt as an additional safety device, but they are not a substitute. Most states require all occupants of a vehicle to wear seat belts.

WARNING

Seat belts must be used by ALL passengers whenever the vehicle is moving.Take the following precautions when adjusting and wearing seat belts:

WARNING

Damaged seat belts and seat belt assemblies will not operate properly. Always replace:

Rear seat warmers
While the engine is running, push either of the switches to warm the rear seat. During mild weather or under conditions where the operation of the seat warmer is not needed, keep the switches in ...

Seat Belt Warning Light
Seat belt warning light (for driver's seat) As a reminder to the driver, the seat belt warning light will illuminate and warning chime will sound for approximately 6 seconds each time you tur ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Rain Sensor Repair procedures
Removal     • The dust or foreign substance on the rain sensor have a bad effect upon the rain sensor capability,so protect the sensor surface with protection cover until installing the rain sensor to bracket for accurate funtion. • The coupling pad on the rai ...

Hyundai Elantra AD (2016-2020) Service Manual: SRS Control Module (SRSCM) Repair procedures
Removal 1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least three minutes before beginning work. 3. Remove the floor console. (Refer to Body - "Floor Console Assembly") 4. Remove the center console duct (A) after loosening the ...

© 2018-2021 www.helantraad.com