Hyundai Elantra: Seat Belt Pretensioner / Seat Belt Pretensioner (BPT) Repair procedures

Hyundai Elantra AD (2016-2020) Service Manual / Restraint / Seat Belt Pretensioner / Seat Belt Pretensioner (BPT) Repair procedures

Removal

1.	Disconnect the battery negative cable, and wait for at least three minutes before beginning work.

2.	Separate the front seat belt (A) from the emergency fastening device.

3.	Remove the door scuff trim. (Refer to Body - "Interior Trim")

4.	Remove the center pillar trim. (Refer to Body - "Interior Trim")

5.	Remove the front seat belt upper anchor bolt.

6.	Disconnect the front seat belt pretensioner connector (A).

7.	Remove the seat belt pretensioner (A) after loosening the seat belt pretensioner mounting bolts.

Installation

1.	Remove the ignition key from the vehicle.

2.	Disconnect the battery negative cable and wait for at least three minutes.

Install the seat belt pretensioner.

Tightening torque :

Bolt A : 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

Bolt B : 39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

Connect the seat belt pretensioner connector.

•	Make sure the lock pin is connected in properly.

Install the front seat belt upper anchor bolt.

Tightening torque :

39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

6.	Install the center pillar trim. (Refer to Body - "Interior Trim")

7.	Install the door scuff trim. (Refer to Body - "Interior Trim")

8.	Reconnect the battery negative cable.

After installing the seat belt pretensioner, confirm proper system operation:

A.	Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

Seat Belt Pretensioner (BPT) Description and Operation

Description The Seat Belt Pretensioners (BPT) are installed inside Center Pillar (LH & RH). When a vehicle crashes with a certain degree of frontal impact, the pretensioner seat belt helps ...

Emergency Fastening Device (EFD) Components and Components Location

Components 1. EFD(Emergency Fastening Device) System ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Components and Components Location
Components 1. Piston ring2. Snap ring3. Piston pin4. Piston5. Connecting rod 6. Connecting rod upper bearing7. Connecting rod lower bearing8. Connecting rod bearing cap9. Cylinder block10. Crankshaft upper bearing11. Crankshaft thrust bearing12. C ...

Hyundai Elantra AD (2016-2020) Service Manual: Alternator Description and Operation
Description The Alternator has eight built-in diodes, each rectifying AC current to DC current. Therefore, DC current appears at alternator "B" terminal. In addition, the charging voltage of this alternator is regulated by the battery voltage detection system. The alternator is regulated by th ...