Hyundai Elantra: Rear Suspension System / Rear Coil Spring Repair procedures

Removal
1.
Loosen the wheel nuts slightly.
2.
Raise the vehicle, and make sure it is securely supported.
3.
Remove the rear wheel and tire (A) from front hub.

Tightening torque :
107.9 ~ 127.5 N.m (11.0 ~ 13.0 kgf.m, 79.6 ~ 94.0 lb-ft)

   
Be careful not to damage the hub bolts when removing the rear wheel and tire (A).
4.
Remove the parking brake cable fixed clip (A).

5.
Pull the spanner as a below arrow in order to loosen the cable and then remove the parking cable (A).

6.
Loosen the bolt & nut and then remove the rear shock absorber (A) from the torsion beam axle.

Tightening torque :
98.1 ~ 117.7 N.m (10.0 ~ 12.0 kgf.m, 72.3 ~ 86.8 lb-ft)

7.
Remove the coil spring.

8.
To install, reverse the removal procedure.
Rear Coil Spring Components and Components Location
Components 1. Spring upper pad2. Coil spring3. Spring upper pad ...

Rear Torsion Beam Axle Components and Components Location
Components (1) 1. Torsion beam axle2. Torsion beam axle cover ...

Other information:

Hyundai Elantra AD (2016-2020) Owners Manual: Sliding and Tilting the sunroof
Sliding the sunroof Pressing the sunroof control lever backward or forward momentarily to the second detent position completely opens or closes the sunroof even when the switch is released. To stop the sunroof at the desired position while the sunroof is in operation, press the sunroof contro ...

Hyundai Elantra AD (2016-2020) Owners Manual: Rear Cross-traffic Collision Warning (RCCW) System
System Description Rear Cross-Traffic Collision Warning (RCCW) system The Rear Cross-Traffic Collision Warning (RCCW) system uses radar sensors to monitor the approaching cross traffic from the left and right side of the vehicle when your vehicle is in reverse. The blind spot detection rang ...

© 2018-2025 www.helantraad.com