Hyundai Elantra: Rear Seat Belt / Rear Center Seat Belt Retractor Repair procedures

Hyundai Elantra AD (2016-2020) Service Manual / Body (Interior and Exterior) / Rear Seat Belt / Rear Center Seat Belt Retractor Repair procedures

Replacement
   
•
When installing the belt, make sure not to damage the retractor.
1.
Remove the package tray trim.
(Refer to Interior Trim - "Rear Package Tray Trim")
2.
After loosening the mounting bolts, remove the rear center seat belt retractor (A).

Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

3.
To intall, reverse the removal procedure.
   
•
Replace any damaged clips.
Rear Center Seat Belt Retractor Components and Components Location
Component Location 1. Rear center seat belt retractor ...

Rear Seat Belt Buckle Components and Components Location
Component Location 1. Rear seat belt buckle [RH]2. Rear center seat belt buckle [LH] ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Rear Glass Defogger Printed Heater Repair procedures
Inspection     • Wrap tin foil around the end of the voltmeter test lead to prevent damaging the heater line. Apply finger pressure on the tin foil, moving the tin foil along the grid line to check for open circuits. 1. Turn on the defogger switch and use a voltme ...

Hyundai Elantra AD (2016-2020) Service Manual: License Lamps Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the trunk lid panel. (Refer to Body - "Trunk Lid Trim") 3. Remove the license lamp (A) after disengaging the license lamp mounting clip (B). 4. Replace the bulb (A) after removing a lens. Installation 1. Install ...

© 2018-2025 www.helantraad.com