Hyundai Elantra: Engine Control System / Purge Control Solenoid Valve (PCSV) Specifications

Specification
Item
Specification
Coil Resistance (?)
22.0 ~ 26.0 [20°C(68°F)]

Purge Control Solenoid Valve (PCSV) Description and Operation
Description Purge Control Solenoid Valve (PCSV) is installed on the intake manifold and controls the evaporative purge between the canister and the intake manifold. It is a normally closed sole ...

Purge Control Solenoid Valve (PCSV) Schematic Diagrams
Circuit Diagram ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Rear Wheel Speed Sensor Repair procedures
Removal 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the rear wheel and tire (A) from front hub . Tightening torque: 107.9 ~ 127.5 N.m (11.0 ~ 13.0 kgf.m, 79.6 ~ 94.0 lb-ft)     • Be careful not to dama ...

Hyundai Elantra AD (2016-2020) Service Manual: Blower Resistor (Manual) Repair procedures
Inspection 1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad center panel. ...

© 2018-2026 www.helantraad.com