| Inspection |
|
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the front door trim.
(Refer to Body - "Front Door Trim") |
| 3. |
Disconnect the motor connector from the motor.
|
| 4. |
Connect the terminal No.1 and No.2 to battery voltage (12V)
and check that the motor operates smoothly when connecting the terminals
below.
[Safety Window Motor]
|
| 5. |
Connect the motor terminals directly to battery voltage (12V)
and check that the motor operates smoothly. Next, reverse the polarity
and check that the motor operates smoothly in the reverse direction. If
the operation is abnormal, replace the motor.
[Standard Window Motor]
|
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the rear door trim.
(Refer to Body - "Rear Door Trim") |
| 3. |
Disconnect the motor connector from the motor.
|
| 4. |
Connect the motor terminals No.1 and No.2 directly to battery voltage (12V) and check that the motor operates smoothly.
If the operation is abnormal, replace the motor.
[Safety Window Motor]
|
Power Window Motor Schematic Diagrams
Power Window Switch Components and Components LocationHyundai Elantra AD (2016-2020) Service Manual: Adaptive Front Lighting System Description and Operation
Description
AFLS Unit (ECU)
AFLS located in Cockpit Module is provided information of vehicle. (steering wheel signal,vehicle speed, inclination of vehicle)
Based on provided information, it calculates algorithm and adjust Low beam of H/Lamp.
It transmits driving information by using LIN prot ...
Hyundai Elantra AD (2016-2020) Service Manual: Blower Unit Components and Components Location
Component Location
1. Blower unit assembly
Components
1. Seal2. Intake duct case3. Intake actuator4. Intake door5. Intake duct case [A]6. Air filter cover7. Air filter8. Blower unit pad9. Blower upper case10. Cluster ionizer11. Blower lower case12. Power mosfet13. Resistor14. Blower moto ...