Hyundai Elantra: Blower / Power Mosfet Description and Operation

Description
It is installed to the DATC and adjusts the fan rpm by precisely controlling the voltage applied to the blower motor.
Blower Motor Repair procedures
Inspection 1. Connect the battery voltage and check the blower motor rotation. 2. If the blower motor does not operate well, substitute with a known-good blower motor and check for proper oper ...

Power Mosfet Repair procedures
Inspection 1. Turn the ignition switch ON. 2. Manually operate the control switch and measure the voltage of the blower motor. 3. Select the control switch to raise the voltage until high ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Driver Airbag (DAB) Module and Clock Spring Repair procedures
Removal 1. Disconnect the battery negative cable and wait for at least three minutes before beginning work. 2. Remove the driver airbag module by putting in a flat tool (O5mm) into the guide hole and then press the spring. 3. Release the connector locking pin, then disconnect the driver ...

Hyundai Elantra AD (2016-2020) Service Manual: Oil Pump Components and Components Location
Components 1. Housing - Oil pump2. Cover - Oil pump3. Gear - Oil pump drive4. Gear - Oil pump driven5. Shaft - Reaction6. Oil - Seal7. Sleeve8. Bearing - Housing9. Cap - Sealing10. Needle roller bearing11. Bolt12. Snap ring - Housing ...

© 2018-2025 www.helantraad.com