Hyundai Elantra: Engine Control System / Injector Description and Operation

Hyundai Elantra AD (2016-2020) Service Manual / Engine Control/Fuel System / Engine Control System / Injector Description and Operation

Description

Based on information from various sensors, the ECM can calculate the fuel amount to be injected. The fuel injector is a solenoid-operated valve and the fuel injection amount is controlled by length of injection time. The ECM controls each injector by grounding the control circuit. When the ECM energizes the injector by grounding the control circuit, the circuit voltage should be low (theoretically 0V) and the fuel is injected. When the ECM de-energizes the injector by opening control circuit, the fuel injector is closed and circuit voltage should momentarily peak.

Fuel Tank Pressure Sensor (FTPS) Repair procedures

Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the FTPS. Specification : Refer to "Specification" Removal 1. Turn the ignition swi ...

Injector Specifications

Specification ItemSpecificationCoil Resistance (?)13.8 ~ 15.2 [20°C(68°F)] ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Air Ventilation Seat Components and Components Location
Component Location [Front Ventilation Seat] 1. Ventilation seat unit (Assist seat only)2. Ventilation seat blower ...

Hyundai Elantra AD (2016-2020) Service Manual: Temperature Control Actuator Description and Operation
Description The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch. Then the temperature will be regulated by ...