Hyundai Elantra: Engine Control System / Crankshaft Position Sensor (CKPS) Description and Operation

Hyundai Elantra AD (2016-2020) Service Manual / Engine Control/Fuel System / Engine Control System / Crankshaft Position Sensor (CKPS) Description and Operation

Description

Crankshaft Position Sensor (CKPS) detects the crankshaft position and is one of the most important sensors of the engine control system. If there is no CKPS signal input, the engine may stop because of CKPS signal missing. This sensor is installed on the cylinder block or the transaxle housing and generates alternating current by magnetic flux field which is made by the sensor and the target wheel when engine runs.

The target wheel consists of 58 slots and 2 missing slots on 360 degrees CA (Crank Angle).

Engine Coolant Temperature Sensor (ECTS) Repair procedures

Inspection 1. Turn the ignition switch OFF. 2. Disconnect the ECTS connector. 3. Remove the ECTS. 4. After immersing the thermistor of the sensor into engine coolant, measure resistanc ...

Crankshaft Position Sensor (CKPS) Specifications

Specification ItemSpecificationCoil Resistance (?)774 ~ 946 [20°C(68°F)] ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Condenser Repair procedures
Inspection 1. Check the condenser fins for clogging and damage. If clogged, clean them with water, and blow them with compressed air. If bent, gently bend them using a screwdriver or pliers. 2. Check the condenser connections for leakage, and repair or replace it, if required. Replace ...

Hyundai Elantra AD (2016-2020) Service Manual: TJ Joint Repair procedures
Disassembly • Special grease must be applied to the driveshaft joint. Do not substitute with another type of grease. • The boot band should be replaced with a new one. 1. Remove the Front Driveshaft. (Refer to Driveshaft Assembly - "Front Driveshaft") ...