Hyundai Elantra: Engine Control System / Fuel Tank Pressure Sensor (FTPS) Repair procedures

Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the FTPS.

Specification : Refer to "Specification"

Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Remove the rear seat.
(Refer to Body - "Rear Seat Assembly")
3.
Remove the fuel pump service cover (A).

4.
Disconnect the fuel tank pressure sensor connector (A).
5.
Remove the fuel tank pressure sensor (B) after releasing the hooks vertically.

Installation
   
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
   
•
Insert the sensor in the installation hole and be careful not to damage when installation.
1.
Installation is reverse of removal.
Fuel Tank Pressure Sensor (FTPS) Schematic Diagrams
Circuit Diagram ...

Injector Description and Operation
Description Based on information from various sensors, the ECM can calculate the fuel amount to be injected. The fuel injector is a solenoid-operated valve and the fuel injection amount is cont ...

Other information:

Hyundai Elantra AD (2016-2020) Owners Manual: Child Restraint System (CRS)
Children Always in the Rear WARNING Always properly restrain children in the rear seats of the vehicle. Children of all ages are safer when restrained in the rear seat. A child riding in the front passenger seat can be forcefully struck by an inflating air bag resulting in SERIOUS INJURY or D ...

Hyundai Elantra AD (2016-2020) Service Manual: Torque Converter Control Solenoid Valve (T/CON_VFS) Specifications
Specifications ? Control type : Normally low type ShapeItems Specifications Control current(voltage) [mA] 0 ~ 850 Supply pressure [kpa (kgf/cm?, psi)] 539.36 (5.5, 78.23) Control pressure [kpa (kgf/cm?, psi)] 0~519.75 (0~5.3, 0~75.38)  Internal resistance(?) 4.8 ~5.4 ...

© 2018-2026 www.helantraad.com