Hyundai Elantra: Timing System / Idler Repair procedures

Removal and Installation
1.
Remove the drive belt.
(Refer to Timing System - "Drive Belt")
2.
Remove the idler (A).

Tightening torque :
39.2 ~ 49.0N.m (4.0 ~ 5.0kgf.m, 28.9 ~ 36.2lb-ft)

3.
Install in the reverse order of removal.
Inspection
Check the idler for excessive oil leakage, abnormal rotation or vibration. Replace if necessary.
Drive Belt Repair procedures
Removal 1. Remove the drive belt. (1) Using the wrench, turning the drive belt tensioner (A) counterclockwise. (2) Disconnect the drive belt (A). (3) Remove the drive belt tensioner (A) ...

Drive Belt Tensioner Components and Components Location
Components 1. Drive belt tensioner ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: General Safety Information and Caution
General Safety Information and Caution Be careful when driving the vehicle using the smart cruise control system as follows.     • The smart cruise control system may have limits to detect distance to the vehicle ahead due to road and traffic conditions. • On curve ...

Hyundai Elantra AD (2016-2020) Owners Manual: Limitations of the System
The Smart Cruise Control system may have limits to its ability to detect distance to the vehicle ahead due to road and traffic conditions. On curves The Smart Cruise Control system may not detect a moving vehicle in your lane, and then your vehicle could accelerate to the set speed. Also ...

© 2018-2023 www.helantraad.com