Hyundai Elantra: Fuel Delivery System / Fuel Pump Motor Repair procedures

Removal
1.
Remove the fuel pump.
(Refer to Fuel Delivery System - "Fuel Pump")
2.
Disconnect the electric pump wiring connector (A) and the fuel sender connector (B).

3.
Remove the head assembly (A) after releasing the cushion fixing hooks.
4.
Disconnect the fuel tube quick-connectors (B).

5.
Remove the fuel sender (A) in the direction of an arrow.

6.
Remove the reservior-cup (B) after releasing the fixing hooks (A).

7.
Disconnect the ground (A).

8.
Release the fixing hooks, and then remove the pre-filter (A) and the fuel pressure regulator (B).

9.
Remove the fuel pump motor (A) in the direvtion of an arrow.

Installation
1.
Installation is reverse of removal.
Fuel Filter Repair procedures
Removal 1. Remove the fuel pump. (Refer to Fuel Delivery System - "Fuel Pump") 2. Disconnect the electric pump wiring connector (A) and the fuel sender connector (B). 3. Remove the head ...

Fuel Sensor Repair procedures
Removal 1. Remove the fuel pump. (Refer to Fuel Delivery System - "Fuel Pump") 2. Disconnect the fuel sender connector (A). 3. Remove the fuel sender (A) in the direction of an arrow. I ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Engine Cover Repair procedures
Removal and Installation 1. Remove the engine cover (A).     • To avoid damage, remove the engine cover on room temperature. • To avoid damage of the engine cover, do not disengage both front and rear mounting point at the same time. 2. Install in the rev ...

Hyundai Elantra AD (2016-2020) Service Manual: Repair procedures
Inspection ESC System Bleeding This procedure should be followed to ensure adequate bleeding of air and filling of the ESC unit, brake lines and master cylinder with brake fluid. 1. Remove the reservoir cap and fill the brake reservoir with brake fluid.     • If the ...

© 2018-2025 www.helantraad.com